Are you running KDE or Gnome? If you’re using Gnome, there’s an extension to manage wireguard. I flip a switch in the top bar, and done.

SV08/ voron for the folks that like to tinker (and value not living in a walled garden, Sovol’s hot end/ nozzles not withstanding).

I would call the SV08 hot end/nozzles proprietary-ish. They still published everything on github, which enabled the community to design a modified heat sink (that I got printed on PCBWay). The updated heat sink allows you to swap in an E3D Revo nozzle. That wouldn’t be possible if it was truly proprietary.

The enclosure for my SV08 arrives today. Looks like my first ABS print is decided. I was trying to figure out how to cleanly/neatly arrange a cable on the dash (from the break controller display) so it doesn’t block a couple switches and the stereo. Thanks for the design!

I have an Ender 3V2 that I converted to direct drive with linear rails and CR Touch, and was pretty happy with the reliability of it. I’ve been wanting to build a Voron forever, but the amount of hours to build/cost of a kit (I can’t print ABS) was a barrier to entry.

I just picked up a Sovol SV08, which is a derivative of the Voron 2.4 (there are some proprietary parts on it, but $579 vs. $1000-1200 for a kit, I’m OK with that). I’m pretty happy with it thus far, although it did require some initial tinkering. Here are the highlights:

• Core XY
• Enclosure Ready
• Fast (printed something that took 26 hours on the Ender, and it took less than 4 on the SV08).
• Finicky for the initial z-offset. Heat soak the bed for 30 min at 65 degrees, then run the automatic z-offset.
• Got super frustrated why I couldn’t figure out the inconsistent extrusion/shitty prints. Tightened the tension screw on the extruder. Problem solved (rookie move).

Time will tell if it’s a long term printer, or more of a tinkerer. However, they open sourced it all - and there’s already a ton of mods. Printing the housing for the BTT 5" touchscreen, saving me $50 over buying a touchscreen from Sovol. It might be worth a look.

Gpodder Sync

The problem isn’t with Nextcloud (I had the same issue happen with me). The problem is with the default sync settings on Thunderbird and DAVx5 (at least for me). Thunderbird defaulted to a longer than I wanted synch schedule, so I dropped it down to syncing every 15 minutes. DAVx5 was set to 240 minutes unless the event was created on my phone. Once I updated both schedules to every 15 minutes, I haven’t noticed an issue.